Hi everyone.
Let me start by saying that I have very little electronics knowledge.
I am building a motion enabled racing rig and I am using the following:
Arduino Uno
24v 220w DC Brushless Motor
Cytron MD13S (one each motor)
Meanwell Power Supply (LRS-350-24) 24v 14.6A (one each motor)
Polulu 3775 Shunt Regulator 26.4v 2.80 15w (one each motor) (I was told I needed this)
My question is:
How exactly do I connect the shunt regulator? Shall I connect it like the picture shows?
If so, what fuse value should I use?
Thanks.