Page 1 of 1

MD13S err on "rapid" change in pulse width?

PostPosted: Tue Dec 19, 2023 6:41 pm
by drlove
There was some interference between my current measuring board (INA219) and the MD13S board, after moving it to before the MD13S-board all is working great!


We just received the MD13S that we use with a continuously rotating windshield wiper motor (12v, 2A, brushless).

When starting from 0% PW and increasing the motor sounds really bad and the Err LED is blinking.
When cranking it up to 100% the motor runs OK and no Err LED.
When slowly lowering PW from 100% everything is OK but if we do a rapid decrease/increase in PW the motor starts to sound bad and Err LED is flashing again.

What could be wrong?

Re: MD13S err on "rapid" change in pulse width?

PostPosted: Mon Apr 22, 2024 6:45 pm
by waiweng83

Are you powering up the motor from a switching power supply? Does it able to support the inrush current needed by the motor during acceleration?