Cytron Technical Forum

what the suitable sensor or component to use in detect the wire cut? In the case, i need to detect the location when 1 wire (telecom wire) is cut and this component/ sensor need to send the data to the pic controller. Pls advice, thanks.

hi,

what is meant by wire cut?
a scratch on wire ?
or total separated two pieces


regards,
yh

is total separate into two pieces. thnks.

see a similar post here, same? confusing if you ask the same thing at several places.

hi,


separate into two pieces on any point of the kilometer length of the wire?

detecting the voltage on the wire?

regards,
yh

ya.you are right.its need to detect the separate into two pieces wire on any point of the kilometer length by detecting the voltage on the wire.

I need to build an device to detect the separated wire (eg: TDR) . So i'm wondering which sensor or other component can be use and low cost.

Thanks

heheh... that's require research lah.