Cytron Technical Forum

by **zulpng3** » Tue Aug 19, 2014 12:22 pm

hello.can i get sample source code for flexiforce sensor.

by **ober** » Tue Aug 19, 2014 9:46 pm

You can check this great tutorial from bildr :http://bildr.org/2012/11/flexiforce-arduino/

by **zulpng3** » Thu Aug 21, 2014 12:18 pm

can the force sensor operate without using arduino?

by **yonghui** » Sat Aug 23, 2014 12:26 pm

Any controller you like

by **zulpng3** » Sun Aug 24, 2014 2:36 pm

i'm use this circuit.but MCP 6004 i replace it with LM358N integrate directly to microcontroller 16F877A. can you help me the sample source code without using arduino?

by **yonghui** » Mon Aug 25, 2014 10:51 am

before u starting writing code. its better u setup the flexi force and opamp to see the output signal is working fine. see under osciloscope. reminder MCP6004 maximum working voltage should be 5V not to exceed.

by **zulpng3** » Tue Sep 02, 2014 4:53 am

hello,
i already done the circuit using LM358N and output voltage is abou 3.7 V.can you help me the sample source code without using arduino

by **yonghui** » Wed Sep 03, 2014 12:01 am

Without Arduino... Then what is the controller u are going to use? The output voltage will change when u press the sensor?

by **zulpng3** » Wed Sep 03, 2014 11:11 pm

i'm using microcontroller 16F877A. when i press the force sensor output voltage i obtain is below 5V.

by **larzazral** » Thu Sep 04, 2014 8:19 am

Cytron Technical Forum

i need source code

i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Re: i need source code

Who is online