by cheekang » Mon Nov 08, 2010 7:43 pm
i have using SC16A servo board for control 12 servo motor. SC16A are control by microcontroller. At first, i start, the servo board are able to move follow the programming instruction. then i off the power supply. second time,i switch on again.all the servo motor are turning to some angle first which not follow the instruction of my program.then only turn to the program i set. i try manny time to different instruction. but still the same ... i sure is not my program problem. i believe is some calibration from servo board instruction. so how. ... to disable the move ...