zayedson WROTE:Good morning everyone,
if me and my friend have PR23 multifunction robot, SKPS PS controller starter kit and PS2 wireless controller. Each one of us has one device of each.
So, how i can make sure that
my robot not interfer with his robot..??
Which part i have to edit ?? Is it the programming code ? Or the transmiting frequency ?
I am still begginer
Actually is not about SKPS. SKPS is just reading signal from PS2 receiver, either wireless or wired and translate it into UART.
Interference or not is not decided by SKPS. Is the wireless communication of wireless PS2 itself that have to carter for that.
Just imaging this, if you are using wired PS2 and is connected to 2 different mobile robot as you described will the SKPS in any way cause interference? No, correct?
Same applied when you use wireless, SKPS cannot play the role to caused interference or to avoid interference.
Anyway, what we have tested here is with two units of wireless PS2 and no problem caused. All you have to do is:
1. Activate one of the receiver 1st and further activate one of the PS2 controller. Wait until they pair up.
2. Activate another receiver, and activate the last PS2 controller, they will again pair up.
Then it should be good.