problem with SLD 936 ESD Station

Soldering, Multimeter, Plier, Cutter, Screwdriver.....

Re: problem with SLD 936 ESD Station

Postby ABSF » Tue Dec 06, 2011 7:04 am

goodstudent WROTE:"I just check it with a meter"-ABSF
what thing your checked? is temperature of iron,continuity ,voltage or something else..

My iron is different from yours. It has only 4 points. 2 of them are for the iron heater element and the other 2 for the heat sensor. I think the heat sensor is just a thermo-resistor, where the resistance changes with heat. When I measured the heater element the resistance was consistant no matter how I shook the iron cable. But when I measured the sensor resistance it was sometimes open circuit and sometimes got resistance when I shook the cable. That's why I said the "sensor is intermittent".

The problem was solved after I replaced the iron.

The next war will determine NOT who is right BUT what is left.
User avatar
Posts: 810
Joined: Wed Nov 10, 2010 9:32 am
Location: E Malaysia


Return to Tool and Equipment

Who is online

Users browsing this forum: No registered users and 0 guests