Help! Xbee AT command.

Bluetooth, XBee, RF......

Help! Xbee AT command.

Postby Myline » Sun Dec 18, 2011 10:59 am

Hi guys,from cytron tutorial,the example show 1 way digital communication rite.
Somebody know how to modify it to become analog form
which means the system is continuously monitoring in every second.
Attachments
Xbee 1 way programming.jpg
AT command for two Xbeepro
Myline
Newbie
 
Posts: 9
Joined: Sun Dec 18, 2011 10:49 am

Re: Help! Xbee AT command.

Postby Myline » Sun Dec 18, 2011 11:11 am

There are many pins for input and output in Xbee pro either analog or digital form,
what command is used to specific the destination i set to input(digital form) Xbee.
For example,if my input is link to one sensor,then sensor(digital form)
is specific to 1 destination of input(digital form) on Xbee.What command is using for?
Simple word,a digital sensor link to input of Xbee using what command
used to specific the destination of input and in digital way communication...
Attachments
pin signal Xbee pro.jpg
PIN signal for Xbee pro
Myline
Newbie
 
Posts: 9
Joined: Sun Dec 18, 2011 10:49 am

Re: Help! Xbee AT command.

Postby ober » Mon Dec 19, 2011 2:57 pm

You can refer to one of Cytron's DIY project, PR20: XBee-Standalone Control and Monitoring. It configure the analog input on the receiving site and output PWM on another XBee module. Should be helpful.
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1486
Joined: Wed Apr 15, 2009 1:03 pm

Re: Help! Xbee AT command.

Postby Myline » Wed Dec 21, 2011 10:24 pm

thank a lot ^^
Myline
Newbie
 
Posts: 9
Joined: Sun Dec 18, 2011 10:49 am


Return to Wireless Device

Who is online

Users browsing this forum: No registered users and 12 guests

cron