Autonomous Robot, Manual Robot, DC Motor Driver, Stepper Motor Driver, Servo, Multi PWM chip.....

Re: PSC28A

Postby ABSF » Sat Dec 17, 2011 5:55 pm

The PSC28A is a cytron inhouse product. There is no schematics or the PIC software open to public for it.

"If you still insist that it is faulty, you can always fill in the form under Cytron website (is under support tab), their technical team will follow up with you." as suggested by Robosang and ober.

The next war will determine NOT who is right BUT what is left.
User avatar
Posts: 810
Joined: Wed Nov 10, 2010 9:32 am
Location: E Malaysia

Re: PSC28A

Postby bawangkulit2007 » Sun Dec 18, 2011 11:01 pm

Hello all. I tried to control the speed of VEXTA Brushless Motor (BLH 230K) using PSC28A. I did the wiring by refering toPSC28A manual page 24 & 19, and BLH series manual page 29. The PWM signal was OK but motor was not running at all.
Is there any wiring diagram that I missed?
Posts: 1
Joined: Sun Dec 18, 2011 10:25 pm

Re: PSC28A

Postby ober » Mon Dec 19, 2011 3:01 pm

Can you please show us the exact connection/interface of your setup? A hand drawing schematic or photos capturing the board should be helpful.
Ober Choo
Cytron Technologies Sdn Bhd
User avatar
Posts: 1455
Joined: Wed Apr 15, 2009 1:03 pm

Re: PSC28A

Postby robosang » Thu Dec 22, 2011 10:46 pm

Yup, a photo of the wiring should help us to understand the connection/setup a lot. 8-)
Posts: 1239
Joined: Wed Jun 10, 2009 5:37 pm


Return to Robot Controller

Who is online

Users browsing this forum: No registered users and 0 guests