hello fyp09,
continuing your question from last post:
http://forum.cytron.com.my/viewtopic.php?t=10311Xbee module has Dout(pin2) and Din (pin3) which are equivalent to UART communication pins Tx and Rx pins. if you are using a computer to communicate with the module, you probably will choose to use either COM port/ serial port(with voltage level shifter such as MAX 232 and voltage divider to get the voltage level correct) or use a FT232 chip to get a virtual COM port and this chip is good that the voltage level is readily suitable to Xbee module (3.3V). For simplicity, just get SKXbee from cytron, which it has the FT chip onboard already and also it has 5V input output for normal applications.
fyp09 WROTE:How to communicate with xbee without using X-CTu maybe by using java or VB.
without using XCTU software, for sure you can write your own software to create the serial communication with the Xbee module.
yh
regards