Mini Mobile Robot Controller(MC40A)

Autonomous Robot, Manual Robot, DC Motor Driver, Stepper Motor Driver, Servo, Multi PWM chip.....

Mini Mobile Robot Controller(MC40A)

Postby hanifnayan » Mon Apr 22, 2013 6:59 pm

Mini Mobile Robot Controller(MC40A)
if i want to control 4 motor .. can Mini Mobile Robot Controller(MC40A) do it... i notice this microcontroller can support 2 motor.. other 2 motor , i think to build their own driver...

other what is mean by Free IO pins are extended out for further development.... how many input that their have...

thank you..
hanifnayan
Greenhorn
 
Posts: 3
Joined: Mon Apr 22, 2013 6:51 pm

Re: Mini Mobile Robot Controller(MC40A)

Postby robosang » Mon Apr 22, 2013 11:50 pm

I have 1 MC40A from last year 1 cent promotion :)

The on board Driver is L293B, you should be able to control up to 1A of current for motor. Extra 2 motor you need to use the free IO. The free IO means the part where you see the header pin at prototyping area, near to LCD.
robosang
Expert
 
Posts: 1239
Joined: Wed Jun 10, 2009 5:37 pm

Re: Mini Mobile Robot Controller(MC40A)

Postby hanifnayan » Thu Apr 25, 2013 11:05 pm

is that the correct connection of L293B..
L293B-pinout.jpg
PIN OUT OF L293D
L293B-pinout.jpg (12.99 KiB) Viewed 3262 times



board layout.jpg
board layout of MC4OA

is that true that C is represent the free IO that ur talking about. ..
if true how many port/pin that are available(not used)..
if ur have any picture may its will help me...

thank you su much for helping me...
thank a lot.......
hanifnayan
Greenhorn
 
Posts: 3
Joined: Mon Apr 22, 2013 6:51 pm

Re: Mini Mobile Robot Controller(MC40A)

Postby robosang » Sat Apr 27, 2013 8:53 pm

If you look at the User's Manual clearly, it do state that the pins under the prototyping section are the free IO pins.

Also, check the schematic.
robosang
Expert
 
Posts: 1239
Joined: Wed Jun 10, 2009 5:37 pm

Re: Mini Mobile Robot Controller(MC40A)

Postby hanifnayan » Mon Apr 29, 2013 3:34 pm

sir .. thank for the feedback...
what i was dont's understand is connection... i mean wiring to the other 2 motor and the input so that i cant control its at the programming....

i ur have any pic pls upload here...
hanifnayan
Greenhorn
 
Posts: 3
Joined: Mon Apr 22, 2013 6:51 pm


Return to Robot Controller

Who is online

Users browsing this forum: No registered users and 20 guests

cron