Hi,
My current set up: Arduino controlling speed(PWM pin) and direction(digital pin) of the motor through the MD30C controller which is wired to a 12v SLA battery.
Issue: My motor isn't able to draw enough current to carry on load. (Sending of analogwrite 255[max speed] isn't sufficient)
However, if I power my motor directly via the 12V SLA, it is able to draw enough current to produce enough torque to carry on my load.
So I would like to be able to achieve the same result through the MD30C.
May I ask how can I produce the same amount of power/torque through the MD30C as it is limiting my current supply to my motor.
Thanks for any help!