Heat a borad

LINIX Brushless, VEXTA Brushless, RC Servo, DC Geared, Linear, Stepper, Tamiya.....

Heat a borad

Postby heppoko » Fri Jul 06, 2018 9:08 pm

Hi,

I am using to drive 24V 3A DC motor by MD10C. The board gets heat just by connecting the power supply. Temperature is about 60~70 degrees. More more heat when motor is moving. Is this normal? Not burning now but I worry to burn the board. Do I need to cool the board? Everyone use cooling fan?
I know the stress test video, it is heat until 117 degrees with no cooler. Is this no problem?
heppoko
Greenhorn
 
Posts: 3
Joined: Fri Jul 06, 2018 8:48 pm

Re: Heat a borad

Postby Idris » Mon Jul 09, 2018 5:17 pm

Hi heppoko,

It is not normal the driver heat up without load. Could you share a few clear photos/video on your hardware setup?
Cytron Technologies invest time and resources providing tutorial, training and support for STEM education and maker movement. We need your support by purchasing products from Cytron Technologies. Thanks.
http://www.cytron.com.my
User avatar
Idris
Moderator
 
Posts: 409
Joined: Thu Mar 22, 2012 5:28 pm
Location: Pulau Pinang

Re: Heat a borad

Postby heppoko » Tue Jul 10, 2018 1:09 pm

Thank you for replay.

1.jpg
Connectioin


I only connected from Power unit to driver. The power supply unit I use is TDK-lambda RWS150B-24.

https://www.us.tdk-lambda.com/lp/produc ... sb-series/

2.jpg
heat area


Turn on the power and listen carefully, I hear the high frequency sound from the driver.
I have several MD10C driver boards. Each board is the same heat. Is there any problem with the power supply unit?
heppoko
Greenhorn
 
Posts: 3
Joined: Fri Jul 06, 2018 8:48 pm

Re: Heat a borad

Postby Idris » Tue Jul 10, 2018 3:42 pm

Hi heppoko,

Thanks for the clear photos.

The area that you highlighted is 7812 regulator. The heat (on that area) is normal for 24V operation.

Thanks. :)
Cytron Technologies invest time and resources providing tutorial, training and support for STEM education and maker movement. We need your support by purchasing products from Cytron Technologies. Thanks.
http://www.cytron.com.my
User avatar
Idris
Moderator
 
Posts: 409
Joined: Thu Mar 22, 2012 5:28 pm
Location: Pulau Pinang

Re: Heat a borad

Postby heppoko » Wed Jul 11, 2018 8:53 am

Would you please tell me your thoughts on waste heat for these drivers?
heppoko
Greenhorn
 
Posts: 3
Joined: Fri Jul 06, 2018 8:48 pm


Return to DC Motor

Who is online

Users browsing this forum: No registered users and 5 guests

cron