G15 library send package

Autonomous Robot, Manual Robot, DC Motor Driver, Stepper Motor Driver, Servo, Multi PWM chip.....

G15 library send package

Postby pak » Wed Jun 09, 2021 4:20 pm

Hi this is my first use of cube servo and I am trying to send instruction
to turn on cube's led directly from my controller's uart tx pin.
[try to use single wire uart]

Same package as in my Termite terminal receives.[attached file]
Nothing happens to cube[led not on] after sending this packet.
I modified G15 shield c++ to my c code.

What have i missed?
Attachments
termite_g15.png
pak
Greenhorn
 
Posts: 3
Joined: Wed Jun 09, 2021 3:57 pm

Re: G15 library send package

Postby pak » Sat Jun 12, 2021 4:43 pm

I ordered a G15 driver and tested some instruction, can move servo now.
pak
Greenhorn
 
Posts: 3
Joined: Wed Jun 09, 2021 3:57 pm

Re: G15 library send package

Postby A380 » Sun Jun 13, 2021 4:03 pm

pak WROTE:I ordered a G15 driver and tested some instruction, can move servo now.


Good to hear that. FYI, G15 is using half-duplex UART, thus G15 driver is needed in between your controller and G15.
User avatar
A380
Discoverer
 
Posts: 120
Joined: Tue May 19, 2009 2:44 pm
Location: Malaysia

Re: G15 library send package

Postby pak » Mon Jun 14, 2021 3:35 pm

Hi A380
Thanks.
pak
Greenhorn
 
Posts: 3
Joined: Wed Jun 09, 2021 3:57 pm


Return to Robot Controller

Who is online

Users browsing this forum: No registered users and 13 guests