The Maker Pi RP2040 board specifies a maximum VIN voltage of 6V in its documentation. This voltage limit is typically set to ensure the safe operation of the board and its components. While it may be possible to exceed this voltage in some cases, doing so could potentially damage the board or its components.
The reason for the 6V limit might be due to the voltage ratings of specific components used on the board, such as voltage regulators, motor drivers, or other integrated circuits. These components may have certain voltage tolerances, and exceeding those limits could cause them to malfunction or fail.
While you may find servo motors that operate at 7.4V, it's important to note that the voltage specified for the Maker Pi RP2040 board is a guideline to ensure proper and safe operation. Exceeding the recommended voltage can void warranties and may lead to unpredictable behavior or damage.
Candy CrushIf you want to drive motors with a higher voltage, such as 7.4V, you should consider using external motor drivers or other power management solutions that are designed to handle higher voltages. This way, you can ensure compatibility and protect the board from potential damage.